USED 2023 Vermeer BC1000XL GAS

2023 Vermeer Wood Chipper BC1000XL | Engine & Power
72.4 hp Deutz G2.9 L4 gasoline engine (EFI)
Maximum torque: 154 lb-ft @ 1600 RPM
Fuel tank capacity: 20 gallons (compatible with unleaded or E10)
Performance Features
SmartFeed system with automatic feed roller reversal and selectable droop settings
EcoIdle system to reduce engine speed during inactivity (1–5 minutes)
Clutchless PTO engagement at low idle for reduced belt wear
Chipping & Feed System
Chipping capacity: Up to 12 inches diameter
Infeed opening: 12" H × 17" W
Feed table: 32" long, positioned 26" off ground
Feed roller speed: Approximately 118 feet per minute
Horizontal feed roller configuration
Drum & Cutting System
Drum size: 20" diameter × 20" wide
Drum speed: ~2205 RPM
Dual reversible A8 chipper knives
Four-sided bedknife (3.5" × 17.3")
Dimensions & Weight
Length: Approximately 160 inches
Width: 66.5 inches
Height: 101 inches
Weight: Approximately 4,995 lbs
Tongue weight: 520 lbs
Chassis & Tires
Dexter torsion axle rated at 5,200 lbs (optional 7,000 lbs)
Tires: ST235/80R16
Discharge chute: 270° rotation with manual pin lock
Hydraulics & Electrical
Hydraulic tank: 7 gallons
Pump flow: ~3 GPM
Relief pressure: 2,500 PSI
Electrical: 12V system with Group 24 battery
Standard fuel and hour gauges with optional deluxe panel and ACS controller
Safety Features
Dual-position bottom feed stop bar
Four-position upper feed control bar (forward, reverse, neutral, emergency stop)
Hold-to-run safety buttons with adjustable sensitivity

Status: Available
Hours: 215
Weight: 4680.0
Rental Rate: $3800
Rate Schedule: DAY: $570
Rate Schedule: WEEK: $1267
Rate Schedule: 3 MOS: $11400
Rate Schedule: 6 MOS: $22800