NEW EXTREMA RM-11

The Rail-Master is the ultimate jig for coping (tenoning) the ends of door rails for 5 piece door system. Available in 11″ and 16″ versions 11″ Version Typically used for cabinet-door manufacturing 16″ Version Typically used for millwork and entry door construction The Rail-Master firmly clamps the rail down while it floats on a cushion of air using the miter slot for square, consistent and repeatable coping operation. Floats on a cushion of air for smooth, easy operation Use with material thickness from 3/4″ to 2″ thick Proven design for years of trouble free use Variable flotation regulation Miter bar slides along Miter slot for coping cuts Removable miter bar for custom free-floating cuts Accepts templates for straight and custom curved and angled cuts Slack adjustment feature on miter bar Single thumb-lever activation Square grid pattern in base to assist in custom cuts Constructed of aircraft-grade aluminum, with anodized finish Accepts blowout board for splinter-free cuts 1 CFM @ 90 PSI 800 ft/lbs holding Thickness Capacity: 3/4″ to 2″ Holding Pressure: 800 ft/lbs CFM Requirements: 1 CFM @ 90 PSI

* Thickness Capacity: 3/4″ to 2″
* Holding Pressure: 800 ft/lbs
Width Capacity: 11 1/2"
CFM Requirements: 1 CFM @ 90 PSI