USED 1958 WARNER & SWASEY 3500 Lot 14

Swing Over Bed Ways......................................23-1/2"
Swing Over Cross Slide Carriage..........................18"
Center Distance..........................................43"
Spindle Hole.............................................4-3/4"
Spindle Speeds...........................................24 To 851 Rpm's
Spindle Nose.............................................A-15
Chuck Size...............................................20" 3-Jaw
Feeds Cross..............................................0.0025 To 0.082 I.P.R.
Feeds Long...............................................0.005 To 0.167 I.P.R.
Main Motor...............................................40/20 Hp. 480 Volts
Flange Holders...........................................Short 3
Flange Holders Long......................................1
Slide Tool Holder........................................1
Weight...................................................18,000 Lbs.
Floor Space..............................................180" L. X 84" W.
Machine Height...........................................64"
Coolant..................................................Yes
Tool Post 4 Way On Front.................................Yes
Rapid Traverse Front And Rear............................Yes
Fixed Rear Turret........................................Yes
Slide Tools One..........................................Yes
Flange Holders Four......................................Yes

Note:
Machine will be cleaned, painted and cycled with everything working
properly.

Condition:...............................................Good
Note:
Machine Will Have Front & Rear Aprons And Rapid Traverse Box Reconditioned.
Rapid Traverse Drive Box Reconditioned.
New Bearings, In Main Motor.
New Feed And Rapid Shafts. Headstock Cleaned And Flushed.
New Filters And Oil.
New Lockdown Pin And Bushing In Hex And Square Turrets.
New Nut And Screw In Cross Slide.
Gibs Reworked And Refitted.
New 20"4-Jaw Gator Chuck W/ Reconditioning.
Machine May Be Seen Under Power With Proper Notice.
It is recommended that you re-bore the flange tool holders on the rear turret
to ensure they are on center once the machine is level.
Price after reconditioning $69,500.00
Reconditioning will take 16 to 18 weeks after receipt of
Purchase Order.