USED 1960 WARNER & SWASEY 3500 LOT
Overview
Description
3 A Used Warner & Swasey Square Head Saddle Type Turret Lathe
Specifications
| Model | 3500 | 3500 |
|---|---|---|
| Swing | 23.5" | 596.9 mm |
| Center Distance | 43 in | |
| Dimensions | R-L X F-B X Height 64" | R-L X F-B X Height 64" |
| Weight | 15,000 Lbs. | 15,000 Lbs. |
Swing Over Bed Ways......................................23-1/2"
Swing Over Cross Slide Carriage..........................18"
Center Distance..........................................43"
Spindle Hole.............................................6-1/4"
Spindle Speeds...........................................24 To 851Rpm's
Spindle Nose.............................................A-15
Chuck Size...............................................20" 4-Jaw
Feeds Cross..............................................0.0025 To 0.082 I.P.R.
Feeds Long...............................................0.005 To 0.167 I.P.R.
Main Motor...............................................40/20 Hp. 480 Volts
Flange Holders...........................................Short 2
Flange Holders Long......................................1
Weight...................................................15,000 Lbs.
Floor Space..............................................180" L. X 83" W.
Machine Height...........................................64"
Coolant..................................................Yes
Tool Post 4 Way On Front.................................Yes
Rapid Traverse Front And Rear............................Yes
Fixed Rear Turret........................................Yes
Note:
Machine will be cleaned, painted and cycled.
Condition................................................Good
Note Reconditioning:
Machine will have front & rear aprons and rapid traverse box reconditioned.
Rapid traverse drive box reconditioned.
New feed and rapid shafts.
New lockdown pin and bushing in hex and square turret.
New nut and screw in cross slide.
Gibs reworked and refitted.
New bearings in main motor.
New forward, reverse and brake clutch disc in headstock.
Headstock cleaned and flushed.
New filters and oil.
New 20"4-jaw Gator chuck with reconditioning
It is recommended that you re-bore the flange tool holders on the rear
turret to ensure they are on center once the machine is level.
Machine will be cleaned, painted, and cycled.
Price: $79,500.00 for the above work completed.
If you would like the machine reconditioned, the above work
will be started once the P.O. is received.
Estimated time frame 16 to 18 weeks.