NEW TRANSITION NETWORKS COPPER TO FIBER SLIDE-IN MODULE MEDIA CONVERTER

Press to translate Listing Translator by Hindi Portuguese Thai Korean French Chinese Spanish Arabic Japanese German Russian Italian T1/E1 TWISTED-PAIR COPPER TO FIBER SLIDE-IN MODULE MEDIA CONVERTER MODEL: CSDTF1011-105 PROVIDES AN RJ-45 TWISTED-PAIR COPPER CONNECTOR FOR T1 OR E1 SINGALS AND A SET OF RX/TX ST CONNECTOERS TO 850 nm MULTIMODE DUPLEX FIBER-OPTIC CABLE. THE INFO. BELOW IS FOR INFORMATION ONLY. T1/E1 NetworksThe Remotely Managed T1/E1 copper to fiber media converter will provide a solution for users who desire to extend their T1 or E1 circuits over fiber and remotely manage them “in-band” from admin locations. Remote unit "in-band" management Local or Remote Loop-backs on copper or fiber in software mode Loopback switch facilitates local installation Converts the copper ports on T1/E1 devices, such as a PBX or T1/E1 Router, to multimode or single mode fiber Extends distances 2,000 meters over multimode fiber or 80,000 meters over single mode fiber. Switch selectable RJ-45 connectors for T1 or E1 Jitter attenuators optimize Bit Error Rate (BER) performance Network debug procedures make BER testing more convenient Built-in troubleshooting with the addition of a selectable TAOS (Transmit All Ones) switch on the fiber and copper interfaces allows the network engineer to test all T1/E1 equipment on that network segment and ensure the network link. Dry relay contacts enable the media converter to be tied into a separate alarm circuit commonly found in a T1/E1 twisted pair environment. Contacts will be activated on loss of power or loss of fiber link. An LED provides Alarm Indication Signal (AIS) Can be used with fractional T1/E1 circuits LOC. 118 D