NEW CANTEK AMERICA JEN-60

The Cantek Drawer Notcher JEN-60 is designed to both notch and drill drawer boxes to install undermount soft-close drawer slides.  The operation of the machine is simple with a self-indexing drilling unit that’s determined by the position of the drawer for either left or right notching.  With a cycle time of approximately 10 seconds per drawer, you can achieve a high throughput.
Features:

Pneumatic cutter & drill stroke by foot pedal operation.
Cutter stroke and drill speed are adjustable for optimum finish results.
Drill will automatically position for both left and right drawer notches by activating a switch in the fence.
Machine will not cycle unless a drawer is up against the switch for safe operation.
Insert knife cutterhead with solid carbide inserts for optimum finish results and long tool life.
2 ¼” (57mm) wide cutter allows for a wide range of undermount slides.
Comes with insert cutterhead with inserts and ¼” (6.3 mm) solid carbide drill bit.
Capable of notching up to 220 drawer boxes (both left and right) per hour.

Specifications:
 
Main Cutter Motor
3 HP
Notch Dimensions
2 ¼” (57mm) x 0.5” high
Cutter Diameter
10”
Drill Diameter
¼”
Table Size
49” x 22”
Table Height from Floor
32”
Dust Port
4” (670 CFM requirement)
Compressed Air Required
90 – 100 PSI
Machine Dimensions
48” x 37 ¾” x 39 ¾”
Machine Weight
506 lbs.