USED ISMATEC MCP-Z

ISMATEC MCP-Z Standard Peristaltic Programable Pump w WARRANTY

This is a Good Working Ismatec MCP Programmable Peristaltic Dispensing Pump with Gambro Single Port Gear Pump Head. The Actual Item Pictured is the One Being Offered. Unit Comes as Pictured with Gambro Head,  Inlet/Outlet Fittings, Tubing, Tip (on one end), Sinker (on one end),  User's Manual, and Power Cord. Unit will be Guaranteed for 30 Days Allowing Enough Time for Your Lab To Fully Test and Inspect.  

Specifications:

Flow rates: 1 to 7020 mL/min (depending on mounted pump-head)

Channels: One

Operating panel: 7 button membrane key-pad, LED display

Memory: 4 sets of operating parameters can be stored

Operating modes- pumping by drive speed (rpm)

pumping by flow rate (ml/min)

factory-set flow rates for all available tube sizes

dispensing by volume (ml) Up to 17 Liters

dispensing by time (0.1s up to 999hrs)

dispensing by volume within a pre-set time

interval dispensing by volume with a pause

interval dispensing by time with a pause

setting the number of dispensing cycles

pause time setting (from 0.1s up to 999hrs)

roller back-steps for drip-free dispensing

reversible rotation direction

Calibrating function

for flow rate (ml/min)

for dispensing volume (ml)

Speed: 1 - 1000 rpm, resolution 0.1 rpm

Speed control: closed loop control for pressure independent speed

RS232 interfaces- RS232 "in" for operation controlling via PC

RS232 "out" for cascading up to 8 pumps

Analog input Speed control (0-5 or 0-10V / 0-20 or 4-20mA)

Analog output Speed monitoring (0-10VDC or 0-12 kHz)

Digital input: Start/Stop, rotation direction, autostart

Differential pressure: 1.5 bar (21.7 psi) possible (depending on pump-head and tubing material); small tubing diameters may allow higher pressures

Motor typeDC motor

Power consumption100 W

Power: 115/230VAC; 50/60Hz