USED 2012 CONNECTRA 2012 CONNECTRA

General Description:
2012 Connectra 620SC Pipe Fusion Machine.
Seller States: 860 Hours only!
Accessories:
Dies: Included, but is missing 3 sections of one die size.
Recent Work/Modifications:
Seller States:
-Clamping: One cast clamp jaw is cracked and will need to be replaced (visible in the close-up photo).
-Heater Plate: Needs to be rebuilt or replaced. The heating element tested bad (12.0A / 4800W single phase).
Additional Information:
Seller States:
-Sold as-is, where-is.
-Rolling / Wheeled Butt Fusion System.
-Low Hours: Only around 850 original hours on the machine.
-Engine & Hydraulics: Runs great. The machine starts, runs, and all hydraulic components work properly.
-Power Source: Equipped with a 20 HP Honda Engine with a self-contained hydraulic pump and built-in electric generator.
-This is an excellent candidate for a quick rebuild or for highly valuable backup parts if you run a fleet of these rigs.
-This is a heavy-duty, self-contained unit built for butt-fusing polyethylene pipe sizes from 6 inch IPS up to 20 inch IPS (160mm through 500mm).