Your Cart
You don't have any items in your cart.
New | in-Stock

DigiTrak® to Ditch Witch® Sonde Adapter Bumpers – Fits 15" DigiTrak Transmitter in Subsite® / Ditch Witch® Bore Head. Stock number: Q18

Florida, United States
Asking Price
USD $49.00
1 available
724Listings|3Followers
Overview
Construction Equipment Parts

Run your DigiTrak® sonde in a Ditch Witch® bore head — no machining, no rattling.

Ditch Witch drill, DigiTrak locator? A 15" DigiTrak transmitter measures 15" × 1.25". The Subsite® beacon your housing was cut for is about 17.8" × 1.5". Drop the DigiTrak in bare and it slides end to end, sits off-center, and takes every shock the bit does — on a sonde that costs thousands.

This set fixes that. Two molded rubber bumpers push onto the ends of your 15" DigiTrak transmitter and make up the difference in length and diameter, so the sonde sits centered and snug in a standard 17" Ditch Witch / Subsite housing, the same way a factory beacon would. No adapter sleeves, no tools, no changes to the housing. Push them on, load the housing, bolt the lid, drill.

Why rubber bumpers instead of a hard adapter

Fits

Stock number: Q18

Specs

Package includes:

2 new rubber bumpers (one for each end)

Shock absorption — the sonde is cushioned against the housing instead of hammering on steel every time the bit hits rock.
No effect on signal — rubber is non-metallic, so depth, pitch, roll and data range are whatever your transmitter and locator already deliver.
Seconds to install, seconds to swap between housings.
Cheap insurance for a transmitter that costs thousands.

Transmitters: any 15" DigiTrak transmitter — Falcon F5+ / F5 / F2 (15"), classic F5 and F2 (15"), SE, Eclipse, LT, Mark III/IV/V. Not for 19" or 8" transmitters.
Housings: standard 17" Ditch Witch® / Subsite® beacon housings — the ones built for 86B-series and 17T-series beacons.

Loading...
Loading...
Loading...