Baumalight 1P24 3 Point Stump Grinder, 24″ Rotor, 34 Carbide Teeth

The Baumalight 1P24 is a PTO-driven 3-point stump grinder with a 24-inch rotor and 34 replaceable S1000 carbide teeth. It requires a tractor in the 20-45 HP range and uses a slip clutch to protect the driveline when the rotor encounters a heavy load.
1P24 Cutting System
The grinder has no hydraulic remote requirement. Tractor movement controls the feed across the stump, and Baumalight specifies a hydrostatic transmission for this model. The rotor reaches 10 inches above ground and 6 inches below grade, with a maximum horizontal cut of 22 inches. Teeth extend beyond the rotor to improve chip clearance and reduce heat buildup around the cutting wheel.
Baumalight 1P24 Specifications
Tractor Requirements
Confirm the tractor's engine horsepower, PTO horsepower, 540 RPM PTO, hitch category, transmission, rear lift capacity, and hydraulic remotes where applicable. Tractor weight and ballast also need to support the grinder during transport and operation.
Does the 1P24 require tractor hydraulics?
No. Baumalight lists no hydraulic remote requirement for the 1P24.
What transmission does the 1P24 require?
Baumalight specifies a hydrostatic transmission for this model.
Is the 1P24 quick-hitch compatible?
Yes. It uses a Category I hitch and is listed as quick-hitch compatible.